Enhanced electronic transport properties of Te roll-like nanostructures

• E. R. Viana,
• N. Cifuentes and
• J. C. González

Beilstein J. Nanotechnol. 2022, 13, 1284–1291, doi:10.3762/bjnano.13.106

• diffraction of amorphous/nanocrystalline materials [24] were not observed. The EDS point analysis (Figure 3b) shows that nanostructures consist of Te, in agreement with the results of the SAED analysis and the above presented EDS analysis of the sample (Figure 1d). The transfer characteristics of the t-Te NW

Green and scalable synthesis of nanocrystalline kuramite

• Andrea Giaccherini,
• Giuseppe Cucinotta,
• Stefano Martinuzzi,
• Enrico Berretti,
• Werner Oberhauser,
• Alessandro Lavacchi,
• Giovanni Orazio Lepore,
• Giordano Montegrossi,
• Maurizio Romanelli,
• Antonio De Luca,
• Massimo Innocenti,
• Vanni Moggi Cecchi,
• Matteo Mannini,
• Antonella Buccianti and
• Francesco Di Benedetto

Beilstein J. Nanotechnol. 2019, 10, 2073–2083, doi:10.3762/bjnano.10.202

• efficient with respect to those used for silicon-based solar cell production [2][16][17][18][19][20][21][22][23][24][25][26][27]. Most of these processes yield nanocrystalline materials that can be easily dispersed in inks [28][29][30][31][32][33], leading to a plethora of new applications, even processing

Magnetic properties of biofunctionalized iron oxide nanoparticles as magnetic resonance imaging contrast agents

• Natalia E. Gervits,
• Andrey A. Gippius,
• Alexey V. Tkachev,
• Evgeniy I. Demikhov,
• Sergey S. Starchikov,
• Igor S. Lyubutin,
• Alexander L. Vasiliev,
• Vladimir P. Chekhonin,
• Maxim A. Abakumov,
• Alevtina S. Semkina and
• Alexander G. Mazhuga

Beilstein J. Nanotechnol. 2019, 10, 1964–1972, doi:10.3762/bjnano.10.193

• spectroscopy; MRI contrast agents; nanocrystalline materials; NMR spectroscopy; Raman spectroscopy; Introduction Nowadays, magnetic nanoparticles (MNPs) are widely used in biology and medicine. A large number of studies [1][2][3][4] have shown different prospects of their use for sample preparation, in

Nanoporous smartPearls for dermal application – Identification of optimal silica types and a scalable production process as prerequisites for marketed products

• David Hespeler,
• Sanaa El Nomeiri,
• Jonas Kaltenbach and
• Rainer H. Müller

Beilstein J. Nanotechnol. 2019, 10, 1666–1678, doi:10.3762/bjnano.10.162

• the micrometer scale differ from those on the nanometer scale, and this results in distinct changes (e.g., the saturation solubility distinctly increases) [13]. In general, amorphous materials have an even higher Cs than nanocrystalline materials [14]. Thus, it would be more effective to use active

Zn/F-doped tin oxide nanoparticles synthesized by laser pyrolysis: structural and optical properties

• Florian Dumitrache,
• Iuliana P. Morjan,
• Elena Dutu,
• Ion Morjan,
• Claudiu Teodor Fleaca,
• Monica Scarisoreanu,
• Alina Ilie,
• Marius Dumitru,
• Cristian Mihailescu,
• Adriana Smarandache and
• Gabriel Prodan

Beilstein J. Nanotechnol. 2019, 10, 9–21, doi:10.3762/bjnano.10.2

• dopant concentration). Keywords: laser pyrolysis; nanoparticles; optical bandgap; Zn/F-doped SnO2; Introduction Recently, there has been growing interest in the field of transparent conducting oxides and wide bandgap oxide nanocrystalline materials such as tin oxide (SnO2). It is generally agreed that

Process-specific mechanisms of vertically oriented graphene growth in plasmas

• Subrata Ghosh,
• Shyamal R. Polaki,
• Niranjan Kumar,
• Sankarakumar Amirthapandian,
• Mohamed Kamruddin and
• Kostya (Ken) Ostrikov

Beilstein J. Nanotechnol. 2017, 8, 1658–1670, doi:10.3762/bjnano.8.166

• crystallinity to facilitate grain growth in nanocrystalline materials. This trend, clearly shown in Figure 3c, implies that the initial growth of the vertical sheets can be attributed to the relaxation of stress that starts at grain boundaries of NG islands. The higher growth rates at high temperature could be

Atomic structure of Mg-based metallic glass investigated with neutron diffraction, reverse Monte Carlo modeling and electron microscopy

• Rafał Babilas,
• Dariusz Łukowiec and
• Laszlo Temleitner

Beilstein J. Nanotechnol. 2017, 8, 1174–1182, doi:10.3762/bjnano.8.119

• liquid was rapidly quenched on the surface of a rotating copper wheel with a linear speed of 30 m/s. Moreover, the ejection over-pressure of the molten alloy under argon atmosphere reached a value of 0.03 MPa. The glassy samples were annealed at 473 K for 1 h to obtain nanocrystalline materials. The

A new approach to grain boundary engineering for nanocrystalline materials

• Shigeaki Kobayashi,
• Sadahiro Tsurekawa and
• Tadao Watanabe

Beilstein J. Nanotechnol. 2016, 7, 1829–1849, doi:10.3762/bjnano.7.176

• high performance nanocrystalline materials, especially those produced by electrodeposition and sputtering, is discussed on the basis of some important findings from recently available results on GBE for nanocrystalline materials. In order to optimize their utility, the beneficial effects of grain

• boundary microstructures have been seriously considered according to the almost established approach to GBE. This approach has been increasingly recognized for the development of high performance nanocrystalline materials with an extremely high density of grain boundaries and triple junctions. The

• the fractal analysis of the grain boundary microstructure. Keywords: electrical resistivity control; fractal analysis; grain boundary engineering (GBE); intergranular fracture control; nanocrystalline materials; Review Introduction Nanocrystalline metals and alloys have been receiving increased

Scanning probe microscopy studies on the adsorption of selected molecular dyes on titania

• Jakub S. Prauzner-Bechcicki,
• Lukasz Zajac,
• Piotr Olszowski,
• Res Jöhr,
• Antoine Hinaut,
• Thilo Glatzel,
• Bartosz Such,
• Ernst Meyer and
• Marek Szymonski

Beilstein J. Nanotechnol. 2016, 7, 1642–1653, doi:10.3762/bjnano.7.156

• dianhydride (PTCDA); phtalocyanines; porphyrins; rutile; scanning probe microscopy; scanning tunneling microscopy (STM); titanium dioxide (TiO2); Introduction Today it comes as no surprise that photovoltaic devices can be made of materials other than silicon. Nanocrystalline materials accompanied by organic

Effect of triple junctions on deformation twinning in a nanostructured Cu–Zn alloy: A statistical study using transmission Kikuchi diffraction

• Silu Liu,
• Xiaolong Ma,
• Lingzhen Li,
• Liwen Zhang,
• Patrick W. Trimby,
• Xiaozhou Liao,
• Yusheng Li,
• Yonghao Zhao and
• Yuntian Zhu

Beilstein J. Nanotechnol. 2016, 7, 1501–1506, doi:10.3762/bjnano.7.143

• nanoscale twins thinner than its step size. Keywords: nanocrystalline materials; transmission Kikuchi diffraction; triple junctions; twins; Introduction The Hall–Petch relationship has inspired materials scientists to refine grains to increase the strength of materials since the early 1950s [1][2][3

• mechanisms that can simultaneously improve both strength and ductility [5][6][9][10][11]. Consequently, deformation twinning in nanostructured metals has received extensive attention in recent years [10]. Among all of the twinning mechanisms in nanocrystalline materials, partial mission from grain boundaries

• nanocrystalline materials. Up to now, there has been no solid experimental study to verify this issue largely due to technical difficulties. So far, high-resolution transmission electron microscopy (HRTEM) has achieved great success in revealing the atomic-level details of deformation/growth twins, including

Two-phase equilibrium states in individual Cu–Ni nanoparticles: size, depletion and hysteresis effects

• Aram S. Shirinyan

Beilstein J. Nanotechnol. 2015, 6, 1811–1820, doi:10.3762/bjnano.6.185

• nucleation in finite systems [14] and for grain boundary segregation problem as a successful approach to stabilize nanocrystalline materials against grain growth [15][16][17]. Chemical depletion is similar to oxygen starvation in medicine (also called as hypoxia) [18]. The origin of hypoxia is the same

Nonlinear optical properties of near-infrared region Ag₂S quantum dots pumped by nanosecond laser pulses

• Li-wei Liu,
• Si-yi Hu,
• Yin-ping Dou,
• Tian-hang Liu,
• Jing-quan Lin and
• Yue Wang

Beilstein J. Nanotechnol. 2015, 6, 1781–1787, doi:10.3762/bjnano.6.182

• absorption behavior of nanostructure particles. To exclude the possibility of a nonlinear behavior of nanocrystalline materials, we conducted the experiment for Ag2S QDs absorption measurement. Figure 7 shows the output energy as a function of the input pump energy at different concentration values. The

Structural transitions in electron beam deposited Co–carbonyl suspended nanowires at high electrical current densities

• Gian Carlo Gazzadi and
• Stefano Frabboni

Beilstein J. Nanotechnol. 2015, 6, 1298–1305, doi:10.3762/bjnano.6.134

• single spots, and outer, fainter rings with spots apparently randomly arranged. This kind of pattern is typical of nanocrystalline materials with randomly oriented nanograins. To establish the structure of these nanograins the radial integral of the pattern (red curve) was compared to the main

Advances in nanomaterials

• Herbert Gleiter,
• Horst Hahn and
• Thomas Schimmel

Beilstein J. Nanotechnol. 2013, 4, 805–806, doi:10.3762/bjnano.4.91

• of introducing internal interfaces on the nanometer scale not between crystalline structures (leading to nanocrystalline materials) but between non-crystalline, amorphous or glassy structures. These glasses differ structurally from present-day glasses and thus are expected to open the way to an age

• interests are related to the synthesis and processing of nanocrystalline materials and nanostructures with tailored and tunable properties, with a focus on applications in printed electronics and energy materials. The nucleation point for this Thematic Series was an international symposium held in August

Plasticity of nanocrystalline alloys with chemical order: on the strength and ductility of nanocrystalline Ni–Fe

• Jonathan Schäfer and
• Karsten Albe

Beilstein J. Nanotechnol. 2013, 4, 542–553, doi:10.3762/bjnano.4.63

• is also found for ordered structures (L12), where dislocation activity is suppressed. Keywords: nanocrystalline materials; grain boundary structure; grain boundary segregation; plastic deformation; molecular dynamics; Introduction In intermetallics grain refinement to the nanometer scale has been

Nanoglasses: a new kind of noncrystalline materials

• Herbert Gleiter

Beilstein J. Nanotechnol. 2013, 4, 517–533, doi:10.3762/bjnano.4.61

• chemical microstructures of glasses in a way comparable to the methods that are used today for crystalline materials. The basic concept of this approach is schematically explained by comparing the microstructures of nanoglasses and of nanocrystalline materials (Figure 3). If we consider a melt of identical

• concentration at the interfaces of the FeSc nanoglass. This enhanced concentration may delay the interfacial delocalization. For example, in the case of Y–Fe nanocrystalline materials grain growth was found to cease due to the solute segregation to the interfaces [29][30][31] (“solute drag effect”) [32][33][34

• remarkable because Fe and Cu are practically immiscible in the crystalline state at similar temperatures (Figure 23). Although the microstructures of multiphase nanocrystalline materials and of multiphase nanoglasses appear similar, there is the following basic difference between the two kinds of

Investigation on structural, thermal, optical and sensing properties of meta-stable hexagonal MoO₃ nanocrystals of one dimensional structure

• Angamuthuraj Chithambararaj and
• Arumugam Chandra Bose

Beilstein J. Nanotechnol. 2011, 2, 585–592, doi:10.3762/bjnano.2.62

• oxide; one dimensional rod; phase transition; Introduction Considerable research interest has been focused on metastable nanocrystalline materials due to their unusual and enhanced properties as compared to their bulk counterparts. Synthesis of metastable nanocrystals with controlled size and shape has